Transmission1

Does anyone have software for the sepura/simoco srm1000 radios, i have Simoco Radio Programming Software - Sepura v4.82 (for Simoco Tetra SRP1000, SRP2000, SRM1000) but i have been told this is a realy old version and is causing me some problems with the radios crashing (displaying engineering mode) and also sometimes the radio will not allow a DMO call with the display showing 'calling...' instead of the radio displaying 'Talk..' and requires power off/on to reset.

cheers

Radios now working after firmware upgrade,

info that came with .drm file -- :

SRM1000 low tx power, about 1 Watt, 1amp drawn, after customising with
V4.40 or later Dealer software.
Radio has old firmware:
Main Micro Boot Code 4313 327 84409 (this was on my radios)
Main Micro Code 4313 327 84745 "" ""
Console 1 Code 4313 327 84396
Mobile Transceiver Authentication Code 4313 327 84273

Solution: download new firmware MN45V013 using programmer

Anyone having similar problems with ex dolphin tetra srm1000's pm me and i will forward newer s/w and firmware, it seems dolphin did not use direct mode and had the software on the radio customised with some of the parameters removed.

cheers

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0367531823

He also has the .DRS file MNV46B005 and PNV46B005 for the SRM and SRP1000

someone else emailed me about the ex dolphin srm1000's , they had got a few and got the v6.x.x software but it would not work with them, i sent the older software and all was fine after the firmware update.

i am having a nightmare finding the oldest cps for the mth800 at the moment.. mr5.1??

Hi, I could do with the firmware to prog my SRM1000's (Ex Dolphin) to support DMO. I have the programming software V4.8.9 but didn't have the firmware upgrade.

regards eproducer

Hi mr_h4ck3rm4n,

Tried PM'ing you and get a message saying "you are not permitted to email this user". Also seem to be having probs with posting a msg to this site too! Let me know if you get this OR that you got my PM.

eproducer

Hi mr_h4ck3rm4n,

Tried PM'ing you and get a message saying "you are not permitted to email this user". Also seem to be having probs with posting a msg to this site too! Let me know if you get this OR that you got my PM.

eproducer

It's due to your membership status, being 'registered' only somewhat limits you (posts pre-moderated, no PM's, etc.)

hello give me MN45V013 or MNV46B005yu
after a power repair, the srm1000 reports incomplete software. I suspect data corruption 28f800. boot I work

found it myself. put it here

thanks for the archive, im new in srm1000