here ya go zephyr , not finished but getting there

Post by **George EI7KO** » 25 Sep 2014, 17:19

Let's be seeing inside then....

Post by **Mattylad** » 25 Sep 2014, 19:16

I'm waiting for the letraset to be dug out

Post by **George EI7KO** » 25 Sep 2014, 20:17

A trip to the engravers would be better.

Post by **bigpimp347** » 25 Sep 2014, 21:31

no just use a red dymo, it'll make it look more authenic,
spending money on laser etching and letrasett won't make it look any better

Post by **nostradamus** » 26 Sep 2014, 08:33

might engrave when i stop changing it , the signal meters new lot bigger than last one, tone been reinstated counter to go in yet and someones mentioned bigger channel led so not time to engrave yet

Post by **zephyr** » 26 Sep 2014, 11:42

Your getting there Mark, I'd use a green channel LED the same as the ones in a Jumbo available from Rapid electronics.
I have red LED's for the Jumbo you can have one just so you can work out the wiring till you get the right colour you need.

Post by **nostradamus** » 30 Sep 2014, 16:28

look at this dave http://www.ebay.co.uk/itm/321506358822? ... 26_rdc%3D1

Post by **George EI7KO** » 30 Sep 2014, 17:31

Dont think theres any offset capabilities on that for SSB though....

here ya go zephyr , not finished but getting there

here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there

Re: here ya go zephyr , not finished but getting there